#1 2016-08-22 17:19:17

blackcrowes219
Member
Registered: 2016-08-22
Posts: 1

Scan Clue "Show Range - failed"

Sometimes when using Alt1 for an elite scan clue it works perfectly and shows the range but other times it will give me "Show range - failed". I don't think it's about which place the scan clue is for because @times I've saved clues for later and gone back the next day and it's worked fine. Any suggestions?

Offline

#2 2016-08-22 18:47:10

Skillbert
Administrator
Registered: 2014-12-30
Posts: 699

Re: Scan Clue "Show Range - failed"

It's only designed to work with fully opaque rs3 interface mode. It might also fail if some other interface like the clock is on top of the minimap.

Offline

Quick reply

Write your message and submit

Board footer

Powered by FluxBB